L28 ignition map – sparkTbl_2020-09-07_21.42.04.table

Support Built On Purpose to see this post and a freebie or two!
To view this content, you must be a member of Aaron's Patreon at $3 or more
Already a qualifying Patreon member? Refresh to access this content.


Share on facebook
Share on twitter
Share on pinterest

2 replies on “L28 ignition map – sparkTbl_2020-09-07_21.42.04.table”

Hey Aaron! Looks like it’s requiring a WordPress login to access?

Giving this prompt: “Sorry. Logging in Administrators via Patreon is turned off in options. Please login with your WordPress account first”

Leave a Reply

Your email address will not be published.

On Key

Related Posts

Datalog recording of induced low load knock

Knock control tuning

Knock control tuning is important for any modified EFI engine. In this post I explain theory and practical verification of knock control tuning.

Ignition coil dwell calibration

Why calibrate ignition coil dwell? I am using a distributor based ignition for my EFI build and ignition coil dwell calibration will help optimise various

Megasquirt battery voltage calibration

These days injector behaviour at different voltages is well understood. The speed of opening and amount of fuel delivered vary with voltage. Corrections are made in fuelling calculations to account different performance for differnt voltages at the injector. If what the Megasquirt ECU understands is the voltage at the injector is different in reality, then it is likely fuelling calculations will be incorrect. This is why the battery voltage calibration needs to be correct in your Megasquirt ECU.

Manual Idle Air Control

The ITB idle air control conundrum Idle air control is generally a challenge with individual throttle bodies.  This is from the sensitivity of throttle position